Showing 97–108 of 395 results
The Offenhauser SWIRL T SHIRT is made of medium weight 100% Cotton Blend. Featuring a comfortable crew neck and short sleeves. Vintage Offenhauser “SWIRL” Logo on the pocket front. Vintage “DUAL PORT 360” on sleeve. Comes in Grey.
Offenhauser 3605 Starter Adapter for Oldsmobile. This unit is a must for all 1935-1953 Ford and Mercury-Oldsmobile engine installations. Switches the starter motor to the right side to eliminate interference with the steering gear. Plate to relocate oil filter is also required when starter is moved.
Offenhauser 3614 – Dodge 1955-57 Dual Quad Low Rise 500 Manifold 315 Cubic Inches and 500 Engines. Also fits 1958 – 325 cu in engines.
Offenhauser 3615 – Dodge 1955-57 Triple D 500 Manifold Available in 3 bolt and 4 bolt variations. Fits 315 and 325 engines.
55-57 PACKARD,NASH, & HUDSON ohv V8 to early FORD & MERCURY transmissions
Offenhauser 3640 LaSalle-Cad Trans Adapter. Has early Ford mounting flange or bolt pattern. Adapts to any other adapter that has Early Ford Trans Flange. From there to Cad or LaSalle Trans. Uses stock Early Ford Clutch Release, shaft, fork, throw out bearings, etc. This allows the us of the mentioned transmission in place of the Early Ford type. Used after the installation has been made with an Early Ford trans., and same does not stand up. When using this adaptor, no clutch linkage changes are necessary, such as pendulum pedals, slave cylinder, etc.Please note that this product is currently not being manufactured by Offenhauser.
The Offenhauser 3660 Accepts two 3 bolt 97’s on a small Rochester or Holley 4 barrel – Manifold The new Offenhauser “2×4” adapter. The ONLY adapter which allows you to mount two of the popular Stromberg 3 bolt carburetors in place of either an early or late quad carburetor. This universal “2×4″ adapter fits…
The Offenhauser 3661 Breather: Is designed to relieve pressure in valve covers Gives your engine that professional appearance Very popular – Attractive Mounts on most stock covers. Small – easy to install If breathers are to be installed on custom style valve covers, it will be necessary to remove a fin.
Not a falsie! Polished aluminum “Gets the Job Done.”
Approximately 2″ wide at top and 1 1/4 ” high. Complete with gaskets.
The Offenhauser 3858 accepts 3 bolt carbs on a 2 bolt adaption A base. The stud to stud spacing on our adapters are as follows: Offenhauser 3859 – 2 15/16″ Offenhauser 3858 – 2 5/8″
