Showing 85–96 of 305 results
-
$511.00
Offenhauser 3640 LaSalle-Cad Trans Adapter. Has early Ford mounting flange or bolt pattern. Adapts to any other adapter that has Early Ford Trans Flange. From there to Cad or LaSalle Trans. Uses stock Early Ford Clutch Release, shaft, fork, throw out bearings, etc. This allows the us of the mentioned transmission in place of the Early Ford type. Used after the installation has been made with an Early Ford trans., and same does not stand up. When using this adaptor, no clutch linkage changes are necessary, such as pendulum pedals, slave cylinder, etc.Please note that this product is currently not being manufactured by Offenhauser.
-
$48.00
Offenhauser Oil By-Pass Unit for Buick V8 thru 1960.
-
$190.00
The Offenhauser 3660 Accepts two 3 bolt 97’s on a small Rochester or Holley 4 barrel – Manifold The new Offenhauser “2×4” adapter. The ONLY adapter which allows you to mount two of the popular Stromberg 3 bolt carburetors in place of either an early or late quad carburetor. This universal “2×4″ adapter fits…
-
$80.00
The Offenhauser 3661 Breather: Â Is designed to relieve pressure in valve covers Gives your engine that professional appearance Very popular – Attractive Mounts on most stock covers. Small – easy to install If breathers are to be installed on custom style valve covers, it will be necessary to remove a fin.
-
$67.00
Not a falsie! Polished aluminum “Gets the Job Done.”
Approximately 2″ wide at top and 1 1/4 ” high. Complete with gaskets.
-
$8.00
Offenhauser 3661 JR-G Breather Gasket
-
$44.00
The Offenhauser 3858 accepts 3 bolt carbs on a 2 bolt adaption A base. The stud to stud spacing on our adapters are as follows: Offenhauser 3859 – 2 15/16″ Offenhauser 3858 – 2 5/8″
-
$49.00
The Offenhauser 3859 accepts 3 bolt carb on 2 bolt adaption B base The stud to stud spacing on our adapters are as follows: Offenhauser 3859 – 2 15/16″ Offenhauser 3858 – 2 5/8″
-
$49.00
The Offenhauser 3860 accepts 3 bolt carb on 4 bolt adaption A base
-
$74.00
Offenhauser 3921S Oldsmobile Water Crossover SPACER ONLY 1957-’58. Sold in a pair. For use with Offenhauser part #3920. Allows 3920 to fit with Oldsmobile 371 CID engines. 1/4″ spacers should be installed between the crossover and the manifold. Gasket not provided.
-
$766.00
“Chev”- With Heat 6 Carburetor Pacesetter Manifold for 348 ONLY, NOT 409.
-
$81.00
This Offenhauser carb adapter will work on their flathead 4 brl intake manifold (also Y-block Ford and other apps) to put on either a Carter AFB, Edelbrock Performer or Holley std bore 4 brl. ( AFB or Edelbrock won’t work on 48 and earlier engines because of the water outlets).  The manifold base measurement is 3 & 7/8″ X 3 & 3/4″.  It is prox 1/2″ thick.
Holley 4 bl Carb to Carter AFB & Small Rochester 4 bl manifold
