Offenhauser 5970 Ford 6 Cylinder Manifold 170/200/250

$615.00

5970 – Ford 6 Cylinder Manifold 170/200/250. 1970 and later Ford 170-200-250 C.I 6 Cylinder Triple Manifold.

This 360 manifold is designed to use a 1974 or earlier stock carburetor in the center and two smaller venturi carburetors on each end. (Small 2 bolt 2-5/8″). The special throttle linkage is a progressive type, which opens the center carb first and then the end ones. Manifold comes complete with linkage and detailed instructions for proper installation.

NOTE: It is necessary to remove the cylinder head to install the manifold.

2 in stock

Description

 

The Offenhauser 5970 intake manifold is designed specifically for Ford inline six engines with the “flat log” style cylinder head, which were used from 1970 and later. This includes Ford 200 and 250 cubic inch straight-six engines found in vehicles such as the Ford Mustang, Ford Falcon, and similar models from that era with the correct head. It will not fit earlier Ford sixes with the “round log” style head unless the head has been machined flat, but this is not standard and requires custom work. If your vehicle has a 1970 or later Ford 144, 170, 200, or 250 cubic inch inline-six engine with the flat mount surface for the intake, the 5970 is the correct manifold to use.

If you have a 1969 or earlier Ford inline-six with the “round log” style, you would want part number 5205 instead. Always verify the head type on your engine before ordering, especially if it is an engine swap or custom setup.

Additional information

Weight 3.2 kg

Reviews

There are no reviews yet.

Be the first to review “Offenhauser 5970 Ford 6 Cylinder Manifold 170/200/250”

You may also like…